9/17/2007REEBOK XL ACTION GRIP® BASKETBALL SYSTEMMODEL #51549ASSEMBLY INSTRUCTIONS AND OWNER’S MANUALSave this instruction in the event that the manuf
10HD9125BHBHDHI(3)(2)(3)3/4” WrenchesHDHI20Attach this end of the Long Extension Arms (AL) to the Backboard BracketsHIHBALTighten the Nut until it is
11HH01300ARARGBAOAOGB(2)GB25 26ANAI27AIWipe off any grease that may be on the Channel (AN) before attaching the Sticker.The bottom of the Height Stick
1230HB(1)HDHK(1)(2)HD9125B3/4” WrenchesTWO PEOPLE REQUIRED FOR THIS STEP.HBHKHKHDALAOHFALHE(1)(1)HEUse the holes closest to the pole.Tighten all Nuts
13Two adults are required to complete assembly. To prevent serious injuries, the pole should be held down by one adult at all times while lling the B
141. Make sure the surface beneath the Base is smooth and free of stones, gravel or other sharp objects that could puncture the Base and cause leaka
15FAUTE DE NE PAS SUIVRE CES AVERTISSEMENTS, VOUS RISQUEZ DE CAUSER DES BLESSURES GRAVES ET/OU DES DOMMAGES À L’ÉQUIPEMENT.SI NO SE OBEDECEN ESTAS ADV
22HARDWARE IS ACTUAL SIZE(Unless otherwise indicated)PARTS LISTID Part # Description Qty TP 1030702 Top Pole 1 MP 1030703 Middle Pole 1 BP 1
3PARTS LISTID Part # Description Qty AN A040031C Inner Channel 1 AO 1030812 Outer Tube 1 AP C050018 Channel Stop 1 AQ 1030748 Pole Brack
4Failure to follow these safety instructions may result in serious injury or property damage and will void the warranty. The owner must ensure that al
5POLE SECTION IDENTIFICATIONIdentify the pole sections before beginning assembly. Failure to assemble the pole sections correctly may result in severe
63BPPAPA4(1)1005748TPThis step cannot be reversed. BPMPBPMP5ATPIn order to seat the poles, strike each end of the pole very hard 5 to 6 times on a pie
7AHMake sure the Rubber Gasket is inside the Base Cap (AH).Rubber GasketScrew the Base Cap (AH) onto the Base.AH6AEAG7 8AGThe Bracket on the Middle Po
87/16” Wrench1/2” Wrenches11HAHLHARBLBHCHCCompletely tighten the Nuts (HA).HCHAHL(2)12(2)(2)RARERERCRDThe Tap Bolts (RE) should be at the outer edge o
9HD9125B(2)(1)HHRI1012253RJRIHH15Only hand tighten the Nuts (HH).Tightening these Nuts later will adjust the Rim tension.HG16HGHGHGThe lower holes sho
Kommentare zu diesen Handbüchern